My shopping cart
Your cart is currently empty.Continue Shopping
In order to properly install Artis Wall gather the following tools:
Unbox planks and let them sit in the room of installation for 10 days to acclimate.
Before beginning the installation process, make sure your walls are clean and free from debris. Wash your wall with clean water and dry thoroughly. Then measure to determine the height of your wall.
Measure and cut A.I.M. strips to the exact height of your wall. You will need (1) A.I.M. strip for every 10-inch to cover the width of your wall.
Beginning at the left side of your wall, peel off the A.I.M. strip backing and apply to the wall. Apply strips vertically every 10-inches apart. Finish with an A.I.M. strip at the far right hand side even if it is less than 10-inches.
First, determine the layout of your planks on the floor. Starting at the bottom-left corner of your wall, begin placing the planks perpendicular to the A.I.M. strips and apply pressure to ensure a tight hold.
Planks come in varied size for easy and quick installation. To trim planks score both sides of the plank with a utility knife and snap.
Step back and enjoy the beauty of your reclaimed wood Artis Wall.
To remove, simply slide your fingers along the top edge of your Artis Wall planks and slowly pull way from the wall until the plank releases from the A.I.M. strips.
After the planks have been removed, peel back a corner of the A.I.M. strip and slowly pull it down the wall at a 45-degree angle.
After all of the A.I.M. strips have been removed, your wall will look just as it did before. No mess, no damage, just peace of mind!
All you need is additional A.I.M. strip! To re-install, start from step two of the step-by-step Artis Wall installation instruction.