Installation

Step by Step

1

GATHER TOOLS

In order to properly install Artis Wall™ you will need the following tools: 1) a utility knife, 2) a tape measure, 3) a straight edge, 4) scissors, and 5) a pencil.

2

MEASURE

Before beginning the installation process, you will want to make sure your walls are clean and free from debris. After washing with clean water and drying the wall, measure to determine the height of your wall.

3

CUT A.I.M.™ STRIPS

Measure and cut A.I.M.™ strips to the exact height of your wall. You will need 1 A.I.M.™ strip for every 10 inches to cover the width of your wall.

4

APPLY A.I.M.™ STRIPS

Beginning at the left hand side of your wall, peel off the A.I.M.™ strip backing and apply to the wall. Apply strips vertically every 10 inches apart. Finish with an A.I.M™ strip at the far right hand side even if it is less than 10 inches.

5

ADD PLANKS

First, determine the layout of your planks on the floor. Starting at the bottom-left hand corner, begin placing the planks perpendicular to the A.I.M™ strips and apply pressure to ensure a tight hold.

6

ENJOY

When all of your planks have been placed on the wall, step back and enjoy the beauty of your reclaimed wood Artis Wall™.

REMOVAL

STEP BY STEP

1

REMOVE PLANKS

To remove, simply slide your fingers along the top edge of your Artis Wall™ planks and slowly pull way from the wall until the plank releases from the A.I.M.™ strips.

2

Peel A.I.M.™ Strips

After the planks have been removed, peel back a corner of the A.I.M.™ strip and slowly pull along-side the wall at a 45 degree angle.

3

NO DAMAGE

After all of the A.I.M.™ strips have been removed your wall will look just as it did before Artis Wall™ was installed. No mess, no damage, just peace of mind.

HOW MUCH ARTIS WALL™ DO YOU NEED?

Calculator

HAVE MORE QUESTIONS?

Check out our Frequently Asked Questions page for answers to some of the most often asked questions.

View FAQs

SIGN UP FOR THE ARTIS WALL™ NEWSLETTER